SNES Controller Buttons Breakout Board

$10.00 USD

Allows you to break out all the buttons on the SNES controller so you could hook them up to your project or to a handheld console such as the GBA etc. This is a DIY part. Works with the original SNES controller and 8bitdo “Retro Receiver for SNES” product, you could even tear their receiver apart and wire it up to save space.

The button pins are Hi-Z so the device should have a pull-up and the button pins are pulled low when activated. Keys are queried every 1 ms. Works from 2v to 5v. The LED on board will blink at boot and light up when a key is pressed.

Questions? Jump on our Discord server where we and other users can help you or contact us via Twitter.

Could work on the GBC, GBA, GBA SP, Micro, etc, you would just need to figure out the wiring of the buttons yourself and find a 3.3v source on the board.

1 ready to build (5-10 days build time) (can be backordered)

Category:

Additional information

Weight 8 g

Installation

1. Take apart your GBA and connect some wires to all the points shown in the image. TP0, TP1, TP2, TP3, TP4, TP5, TP6, TP7, TP8, TP9.

2. Wire up the points to the board.

TP0 = A
TP1 = B
TP2 = SL (Select)
TP3 = ST (Start)
TP4 = R (Right)
TP5 = L (Left)
TP6 = U (Up)
TP7 = D (Down)
TP8 = R (near A on board) – Right trigger
TP9 = L (near A on board) – Left trigger

3.3V = SIN pin on the cart connector
GND = System GND

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.